内容： 我司有一老客户需要一种小水泵，由于我对水泵不是很了界，请看如下内容，看贵司能否生产？一： What is needed for this project is a pump like the C-DM54 pump (4L/Hr as small as possible) but would need:
1. Operate off of 120Vac 60 Hz. 2. Electronic interface to command the pump for a single stroke cycle. 3. Screw drive pumping action. 4. Similar to the 125 strokes per minute is fine but not critical. 5. They like the suction and discharge tube sizing but not critical. 6. 5.6 Bars is OK 二：They need a screw drive pump and not a solenoid driven pump which I believe the JC-DM series is (please confirm). I will design the electronics interface for them so I need the pump to be 120 Vac and the least costly control signal interface option. I do not know pumps very well but the way I understand them is there are several different ways to enable and disable them. There are also settings on the pump to change the Gal/Hr, and so on. Ideally I would like to design the control system to determine the flow rate and then send a signal to the pump to turn on and off. The pump would need no settings or controls other than turn on and off. Then we would want pumps of 1 and 3 Gal/Hr sizes that had tubing interface size 0.17" ID.
：梅方会
：爱力浦泵业
：13958533825
：
